Kenwood VZ907 - Manual (Page 35)

English
35
.........1
!2
The use of any accessories except for those provided might result in
damage to the unit. Make sure only to use the accessories shipped
with the unit, as shown above.
CAUTION
Accessories
.........4 y
.........8
u
External view
......... Number of items
External view
......... Number of items
Installation Procedure
1. To prevent short circuits, remove the key from the ignition and
disconnect the · terminal of the battery.
2. Make the proper input and output cable connections for each unit.
3. Connect the wiring harness cables in the following order: ground,
battery, ignition.
4. Connect the wiring harness connector to the unit.
5. Install the unit in your car.
6. Reconnect the · terminal of the battery.
7. Press the reset button.(See p.4)
• If your car's ignition does not come with an ACC position,
connect the ignition cables to a power source that can be
turned on and off with the ignition key. If you connect the
ignition cable to a power source that receives a constant
voltage supply, as with battery cables, the battery may die.
• If the fuse blows, first make sure that the cables have not
caused a short circuit, then replace the old fuse with one with
the same rating.
• Do not let unconnected cables or terminals touch metal on the
car or anything else conducting electricity. To prevent short
circuits do not remove the caps from unused terminals or from
the ends of the unconnected cables.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Thoroughly wipe away oil and other dirt from the installation
surface.
Please avoid installation on uneven surfaces.
• Mount the unit so that the mounting angle is 30° or less.
CAUTION
.........8
i
.........4
o
.........2
@1
.........4
!0
.........4
!1
.........6
@0
.........2
!4
.........2
!5
ATT
TUNE TRACK
MODE
AME
REAR AV SP
V.SEL
F NC
DSIC 4
¢ 38
FM + AM – +
–
SRC
TV/VD
.........1
!6
.........2
!7
.........1
!8
.........4
!9
.........1
!3
.........2
@2
.........2
@3
.........1
w
.........1
e
.........1
r
.........1
q
.........1
t
Installation