Kenwood VZ907 - Manual (Page 30)

30
English
Station Name Preset (SNPS) /Disc Name Preset (DNPS)
If the cursor is in the desired character input position, go on to step
4. If not, touch either the [
| ] or [ \ ] to move the cursor to the
desired position.
The [
| ] moves the cursor to the left and the [ \ ] moves it to the
right.
Touch the [ ∞ ] or [ 5 ] to switch the character lists.
Touch the character.
Continue steps 1 and 3 until all the characters are chosen for the
name.
• You can enter up to 16 characters for each name.
• To enter a space, touch [ SPACE ]. A blank is inserted and the
cursor moves to the right.
Touch the [ OK ] to finish name entry and leave name preset
mode.
• If you want to change the name of a station, first display the name
of the station (following steps 1 and 2 above), then change the
letter(s) that you want by following steps 3 and 4.
• You can assign names to up to 30 TV stations.
• All the station names will be erased if you press the RESET button.
• You can only store names for up to 100 CDs. If you store the name
for an 101th CD, the first one will be erased automatically.
• CDs are identified by their total length and number of tracks. If you
play another CD that happens to have exactly the same
specifications as another CD whose name is stored, the wrong
name will be displayed for it.
NOTE
5
NOTE
4
3
2
1
NAME SET
B E S T - H
A A
G G
M M
S S
Y Y
B B
H H
N N
T T
Z Z
C C
I I
O O
U U
D D
J J
P P
V V
E E
K K
Q Q
W W
F F
L L
R R
X X
SP SP ACE ACE
Name Preset Function
Music Repeat
Repeatedly plays the track currently being listened to.
Turning Music Repeat On/Off:
Touch the [ REP ] to switch music repeat on/off.
Cancelling Music Repeat:
Touch either the [ REP ] or [ 2 3 ].
Music repeat "knows" where a track begins by detecting the blank
space preceding it (the space between tracks). However, when the
blank space lasts for less than four seconds or contains noise, this
function may not operate correctly. Furthermore, sections that are
recorded at low levels may trigger the function if they last for four
seconds or more.
Index Scan Function
Successively plays the first few seconds of each track on the tape.
Turning Index Scan Function On/Off:
Touch the [ SCN ] to switch the index scan function on and off.
The SCN indicator lights up when the index scan function is turned
on.
Stopping to Listen to the Track Being Scanned:
Touch either the [ SCN ] or [ 2 3 ].
Playback begins as usual.
• The index scan function is cancelled when the tape stops.
• The index scan function "knows" where a track begins by
detecting the blank space preceding it (i.e., the space between
tracks). However, when the blank space lasts for less than 4
seconds or contains noise, this function may not operate
correctly. Furthermore, sections recorded at low levels may
trigger the function if they last for 4 seconds or more.
NOTE
NOTE
Tape Player Control Function