Kenwood DPF-J9010 - Manual (Page 29)

29
CD-2280M/DPF-J9010 (En)
Select “MUTE ON“.
2
MODE
∞ DISC SKIP 5
SET
E S E L T C D T S I S C T E M
Use the following procedure before playing the DTS disc.
1Press the MODE key.
÷ When the MODE key is pressed during DTS ANALOG MUTE mode, the
DTS ANALOG MUTE mode is cancelled.
Preparation
÷ Load DTS discs into the carousel. 0
÷ Check that the Mechanism-A is in the normal
play TRACK mode.
#
1
Activate the DTS ANALOG MUTE mode.
2Select “DTS ANALOG MUTE”.
Select the DTS disc.
3
Select the disc number.
Each press switches the modes as follows:
1 MUSIC TYPE
2 TITLE INPUT
3 ALL DATA READ
4 ALL INFORMATION
5 DTS ANALOG MUTE
÷ The disc number can be selected directly by using the numeric keys in
place of the DISC SKIP keys.
÷ To register another DTS disc, repeat the procedure from step 3.
DISPLAY-A
∞ DISC SKIP 5
Previous disc Next disc
\
To quit DTS ANALOG MUTE mode
Press the MODE key.
To delete the DTS registration
Use the following procedure before moving or changing a DTS disc, and register the disc again.
1Perform steps 1 of “Registration of
DTS discs“.
2Select “MUTE OFF“.
∞ DISC SKIP 5 SET
\
3Select the DTS disc to be deleted.
SET
∞ DISC SKIP 5
Previous disc Next disc
\
To quit DTS ANALOG MUTE mode
Press the MODE key.
SET
Registration of DTS discs
: Keys and controls used in the operations described on this page.
\
∞ DISC SKIP 5
SET
\
Each press switches the modes as follows:
1 MUTE ON
2 MUTE OFF
Each press switches the modes as follows:
1 MUTE ON
2 MUTE OFF
Note Note
When a DTS disc is played, the audio signal is not output at the analog output jacks.