Kenwood DPF-J9010 - Manual (Page 20)

20
CD-2280M/DPF-J9010 (En)
: Keys and controls used in the operations described on this page.
Registration of Title Name
∞ DISC SKIP 5
MODE
SET
SET
∞ DISC SKIP 5
I T L T I E N I U P N T O D M
Registration of Title Name
For discs not corresponding to CD-TEXT, a title name can
be given to the disc (max. 25 characters). Up to 20 tracks
titles can be registered per disc. Operation is possible also
when the door panel is open. It is convenient to register
titles while discs are being inserted.
Enter the title names.
1
Switch to title name input mode.
2
1Press the MODE key.
2Select “TITLE INPUT”.
÷ When the MODE key is pressed during title name input mode, the input
mode is cancelled.
Preparation ÷ Load discs into the carousel. 0
÷ Check that the Mechanism-A is in the normal
play TRACK mode.
#
÷ Set the Mechanism-A to stop mode.
1Select the disc number. ÷ The disc number can be selected directly by using the numeric keys in
place of the DISC SKIP keys.
÷ During playback, the disc only being played can be selected.
Previous disc Next disc
Assigning Title Names
DISPLAY-A : The display flashes.
- D - - T C - - S L E C E T
\
To enter the disc title
\
SET
CHARACTER/SEARCH
DOWN UP
4 ¢
2Select a character.
Press until the character to be entered
comes to the position of the flashing
cursor.
3Press the SET key.
ENTER
4Store the disc title.
Example
ABC
2
For direct selection of characters
÷ When the SET key is pressed, one character is set and the cursor
goes to the next digit.
÷ Repeat this to enter the title name.
Each press switches the modes as
follows:
When capital letters have been selected
: A → B → C → A .....
When small letters have been selected
: a → b → c → a .....
When numbers/symbols have been selected
: 2
To change the character type... £
I T L T I E T S R O ! E O ! M
÷ The characters also can be selected with the DISC SKIP knob on the
main unit (provided that the OPERATION-A indicator is lit). Turn the
knob until the character to be entered comes to the position of the
flashing cursor.
÷ One character is set and the cursor goes to the next digit.
÷ Input the entire disc title by repeating 2 and 3 for each character.
÷ To register the disc names of another disc, repeat the entire procedure
of "To enter the disc title".
÷ To register another track titles in the same disc, go to step 1-2 in “To
enter the track title“.
¡
C A Z B = >
Flashing cursor
÷ To enter track titles without assigning the disc title, go to “To enter the
track title“.
¡