Identifying components for remote control unit – Kenwood Sovereign VR-5700 User Manual

Page 45

mote Setup

Chapter Two : Setting Up the Remote Control Unit

Identifying Components for Remote Control Unit

After the speaker setup, it is required to make Remote Con-
trol unit capable of identifying the devices it controls. Re-
mote Control unit provided with the receiver can be used
in setup of any device. Even when a device is not listed in
the device codes in the Remote Control unit memory, the
remote control function of the device can be programmed
using the Learn function.

The Learn function can also be used to extend the remote
controllable functions.

For details, see “If a device cannot be remote controlled with
any code in the list, or to add remote control target func-
tions...” on page 40.

Registering a device

1. Ensure that the batteries are loaded.

REC

3. Press the Setup button (LCD function button 2).

4. Select “01. IR” using the

button, then press

the Enter button (LCD function button 2).

2. Press the Menu button (LCD function button 2).

REC

01.IR

02.Surround

03.Contrast

Home Enter

Tuner

FMF01ch

F87.50MHz

FFFFFFMenu

REC

HomeFFFSetup

Press the MUSIC button or MOVIE button to display “Menu”.

5. See “Noting Your Devices” on page 3 to check the de-

vices and the jacks to which they are connected.

6. Select a device connection jack name (CD1, MD/Tape1,

etc.) using the

button, then press the Enter

button (LCD function button 2).

7. Select the device name connected to the jack (CD, Tape,

etc.) using the

button, then press the Enter

button.

REC

01.CD1

02.MD/Tape1

03.CD-R

BackFFEnter

REC

01.CD

02.Tape

03.MD

BackFFEnter

REC

Kenwood

Adcom

Aiwa

BackFFEnter

8. Select the manufacturer name of the device using the

button, then press the Enter button.

If the manufacturer name of the device is not listed, se-
lect "Nothing" and press the Enter button. In this case,
the code can be programmed using the Learn function
(see page 40).

REC

01.0505

02.Nothing

BackFFEnter

9. Select the setup code of the device (each device has a

remote control identification number matching it) us-

ing the

button.

• When the device is connected through a Kenwood

system control cord, select System. In this case, the
remote control signal is sent to the receiver then to
the device connected to it.