KVH Industries KVHTRACVISION G4 - Manual (Page 41)

Multiple Multiswitch Installation
If you need to connect more than four IRDs to the TracVision
antenna, you may carry out a multiple multiswitch installation,
as shown in Figure 2-19.
Connecting the IRD Ground Wire
A grounding wire has been provided to connect your IRD to a
suitable ground. Attach the grounding wire to any suitable screw
on the rear panel of the IRD with a good contact with the IRD
chassis. The other end should be connected to a suitable DC
ground, ideally to the ADCU ground terminal (route the ground
wire to the ADCU and leave unconnected for now). Each IRD that
you connect to the TracVision system should have a similar
ground connection.
If you are using a multiswitch, you can ground the multiswitch instead
of the individual IRDs.
54-0147 28
TracVision G4 Technical Manual
Multiswitch
DC In RHCP
+13v
VHF/UHF LHCP
+18v
Out 1 Out 2 Out 3 Out 4
DC Power
Multiswitch
DC In RHCP
+13v
VHF/UHF LHCP
+18v
Out 1 Out 2 Out 3 Out 4
DC Power
IRD #5 IRD #6 IRD #8 IRD #7
RF Splitters/
Power Dividers
IRD #2 IRD #3 IRD #4 IRD #1
TracVision Antenna Baseplate
RF1
RF2
Data
Power
Figure 2-19
Multiple Multiswitch Installation
(North American systems only)
Be sure to connect a ground cable
from each IRD to a suitable DC
ground, ideally the ADCU ground
terminal.