Tracvision g4-hp technical manual addendum, 4 replacing the main pcb and fuses, 6 replacing the antenna gyro assembly – KVH Industries KVHTRACVISION G4 User Manual
Page 11: Eco #7134)
1
54-0147 Addendum to Rev. K
TracVision G4-HP
Technical Manual Addendum
(ECO #7134)
The following changes apply to Revision K of the
TracVision G4-HP Technical Manual (KVH Part Number 54-0147).
The “=TV” configuration command printed in the manual is incorrect.
For your TracVision G4-HP system, the correct configuration command
is =TVG4HPT, not =TVG4HP.
You will need to enter the =TVG4HPT command whenever you replace
the main printed circuit board (PCB) or calibrate the antenna gyro, at
the steps noted below.
5.4
Replacing the Main PCB and
Fuses
Replacing the Main PCB
13. Type
=TVG4HPT
(
5.6
Replacing the Antenna Gyro
Assembly
Calibrating the Antenna Gyro
8. Type
=TVG4HPT
.