Kenwood KDC-MPV7023 - Manual (Page 34)

English
— 34 —
Connecting Wires to Terminals (KDC-MPV7023/6023/5023)
ANT.
CONT
P.CONT
FRONT • L
FRONT • R
REAR • L
REAR • R
– +
FRONT
AUX IN
FM/AM antenna input 1
KDC-MPV7020
Fuse (10A) 24
2 KENWOOD disc changer control input
Wiring harness
(Accessory1)
25
29
White/Black
32
Gray/Black
35
Green/Black
38
Purple/Black
White
31
Gray
34
Green
37
Purple
40
To front left
speaker
30
To front right
speaker
33
To rear right
speaker
39
To rear left
speaker
36
Ignition wire (Red) 20
Battery wire (Yellow) 21
Ground wire (Black) · (To car chassis) 22
Ignition key
switch
10
Car fuse box
(Main fuse)
11
ACC 13
Car fuse
box
14
Battery
12
If no connections are made, do not let the wire come out from the tab.
To connect the Disc changer, consult
your Disc changer manual.
3
Power control wire (Blue/White) 15
Motor antenna control wire (Blue)
17
Dimmer control wire (Orange / White)
(KDC-MPV7023/6023 only)
18
5 When using the optional power amplifier,
connect to its power control terminal.
To car light control switch
8
7 Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
AUX left input (White)
(KDC-MPV7023/6023 only)
AUX right input (Red)
(KDC-MPV7023/6023 only)
Front left output (White) 23
(KDC-MPV7023/6023 only)
Front right output (Red) 28
(KDC-MPV7023/6023 only)
Rear left output (White)
/ Non-fading left output (KDC-
MPV7023/6023 only) (White)
26
Rear right output (Red)
/ Non-fading right output (KDC-
MPV7023/6023 only) (Red)
27
4a
KDC-MPV7023_U.S r2 02.10.31 10:16 AM Page 34