Operating instructions icc 1 s b/d english, Changing bulbs, Changing fuses – Karcher 1.142-114 User Manual
Page 21: Battery safety instructions, Removing and installing battery
Operating instructions
ICC 1 S B/D
English
44
Changing bulbs
Unscrew the hexagonal head
screws of the headlight holder
Take-out the headlight and
disconnect the cable plug
Note the position of the plug
Unscrew the headlight casing to
take it apart
Pull the headlight casing apart
Hold the headlight casing
horizontally; the headlight is not
attached.
Unlatch the lamp mounting
closing bracket abd take out the
lamp bulb
Replace bulb
Note:
Assembly is carried out in reverse
order.
Changing fuses
Fuses/relays in vehicle tail
1. Electric fan relay
2. Preglow relay (only for ICC 1 S D)
3. Fuse for electric fan
4. Fuse for ignition coil and
preglowing (only for ICC 1 S D)
The fuse box is in the instrument
panel beneath the steering wheel.
—
Replacing blown fuses
—
Use only fuses with the same
current rating
Battery safety instructions
Warning!
Observe the operating
instructions.
Work on batteries is permitted
only after instruction by trained
personnel.
Danger!
Risk of fire and explosion!
Do not place any objects or tools on
the battery because voltage is
always present between the battery
poles.
Areas in which batteries are
charged must be well ventilated, as
highly explosive gas forms during
charging.
Smoking prohibited.
No naked flames, glowing embers
or sparks in the vicinity of batteries.
Danger of acid burns!
Wear safety goggles and
protective clothing.
Observe regulations for the
prevention of accidents as well
as DIN VDE 0510, VDE 0105
T.1.
Rinse out or rinse off splashes of
acid in the eye or on the skin with
copious quantities of clean water.
Then consult a doctor
immediately.
Wash contaminated clothing with
water.
Old batteries with this symbol are
reusable commodities and must
therefore be returned for
recycling.
Old batteries which are not
returned for recycling must be
disposed of as special waste,
thereby observing all statutory
regulations.
Removing and installing
battery
Unscrew rear cover
Unscrew negative pole terminal
Unscrew the battery holder
Take out battery