Konica Minolta DiMAGE S404 - Manual (Page 16)

16
CHANGING BATTERIES
Insert the batteries.
• Make sure the positive and negative
battery terminals are orientated as
illustrated on the diagram in the battery
chamber.
This digital camera uses four AA-size alkaline or Ni-MH batteries. Ni-MH batteries are recommended
because of longer life. When using Ni-MH batteries, fully recharge them with a battery charger
suitable for complex electronic equipment. Please consult your vendor about an appropriate charger.
When replacing batteries, the mode dial should be in the off
position.
• If the camera is not turned off when replacing exhausted batteries,
the low-battery warning may not reset.
Close the battery-chamber door and slide it back toward the body (4) to
engage the safety catch. Move the lock lever (5) to the close
position
.
• After installing the batteries, the set-time/date message may appear on the
monitor. The clock and calendar are set in the custom 2 section of the
setup menu (p. 84).
Open the battery-chamber door by moving the battery-chamber lock (1)
to the open position
. Slide the door forward (2) to release the safety
catch; the door should spring open (3).
1
2
4
3
5
GETTING UP AND RUNNING