Konica Minolta Magicolor 3300 - Manual (Page 15)

EN-15
Inserting an SD Memory Card (optional accessory)
The camera comes with 16MB of internal memory, allowing you to store images and video clips in
the camera. However, you can expand the memory capacity by using an optional SD memory
card so that you can store more images and video clips.
1. Make sure the camera is turned off.
2. Open the card cover.
3. Insert an SD memory card:
The front side of the memory card (printed arrow)
should face towards the rear side of the camera.
If the card cannot be inserted, check the orientation.
This camera is also compatible with MultiMediaCard (MMC).
4. Close the card cover.
To remove a memory card:
Make sure the camera is off. Open the card cover. Press lightly on the edge of the memory card
and it will eject.
Note:
To prevent valuable data from being accidentally
erased from an SD memory card you can slide the write
protect tab (on the side of the SD memory card) to “LOCK”.
To save, edit, or erase data on an SD memory card, you
must unlock the card.
Choosing the Language
When you first turn the camera on, you may need to set the language in which language menus
and messages are to be displayed on the LCD monitor.
Follow these steps below to set the language:
1. Turn the camera on by sliding the
switch.
2. Set the mode dial to the mode.
3. Move to LANGUAGE by using the or button,
and press the button.
4. Select the language that you require by using the or
button.
5. Press the button to confirm.
LOCK LOCK
Write-protected
tab
Write-protected
state