User preferences – Kathrein UFS 822sw User Manual

Page 57

USER PREFERENCES

In this menu you can use the

button to delete the stored tvtv data. You can then have the UFS 822

update the tvtv data at the selected time or press

to switch your receiver to standby. The receiver

automatically starts updating the tvtv data. The progress of the tvtv data update is indicated on-screen. After
updating the data, the receiver automatically switches back to Standby. You can now restart the receiver by

pressing the

button.

Here use the

buttons to select the number of minutes before the time set in the EPG at which the

recording should start. You can choose a value between 1 minute and 10 minutes, in 1 minute increments.
The recording will start that number of minutes before the due time. This allows a contingency for small
variations in transmission times. Unwanted parts of the recording can later be discarded, as described in the
Chapter “Recording List” under “Edit Recordings”, “Cut”.

Here use the

buttons to select the number of minutes after the time set in the EPG for which the

recording should run on. You can choose a value between 1 minute and 30 minutes, in 1 minute increments.
The recording will stop that number of minutes after the due time. This allows a contingency for small
variations in transmission times. Unwanted parts of the recording can later be discarded, as described in the
Chapter “Recording List” under “Edit Recordings”, “Cut”.

RECORDING LEADING OFFSET

RECORDING FOLLOWING OFFSET

INVALIDATE TVTV-DATA

If the tvtv EPG data are older than
36 hours, or had previously been
deleted by the “Invalidate tvtv-data”
command, the receiver updates
the tvtv EPG data automatically,

provided that the

button had been

pressed to place the receiver in
standby mode. The update can be

interrupted by pressing the

button

a second time.

DYNAMIC SI HANDLING

Use the

buttons to select “On” or “Off”. When the receiver is switched on, it automatically uses the

program names broadcast by the transmitter. Setting this to “Off” allows you to change the program names,
and prevents the receiver automatically changing those names back to the broadcast setting.

This manual is related to the following products:

UFS 822si