Kathrein UFS 822sw - Manual (Page 23)

23
Press the buttons and the button to
select the satellites from which you want tuners
1 and 2 to receive signals. Press the button
to confi rm your selection; the chosen satellite
is then moved into the tuner satellite list on
the right.
If you have unintentionally transferred a satellite
into the list on the right, you can press the
"
(yellow) button to switch between the lists, and
then press the button to remove the satellite
concerned.
When you have selected all the satellites you
want, press the
!
(green) button.
FIRST INSTALLATION
If the LNB type used in your reception system
is a single-cable LNB, the setting must be
“Wideband” LNB. If a Universal LNB is used
with a single-cable matrix, the setting must be
“Universal” LNB (for this, refer to the product
information, user instructions and manuals for
the LNB and for the matrix).
For “LNB Type” perform here a suitable setting for
your reception system, “Wideband” or “Universal”.
The “22kHz Control” must be set to “Off” and the
“DiSEqC™ Input” must be set to “Disable”.
You can see whether the confi guration is correct
for your reception system by viewing the test
transponder signal strength (selection by pressing
the buttons).
Display of the frequencies selected by the receiver
(example):
Single-cable frequency 0–1400 MHz
Single-cable frequency 1–1516 MHz
The receiver now automatically performs the
confi guration (setting the LNB frequency and the
LNB type).
Once the automatic confi guration has been
completed, the received displays an overview for
you. Now press the button.
The receiver now checks whether two free
single-cable frequencies are available for the
receiver to use.