Kenwood KAC-746 - Manual (Page 7)

7
A
B
A
B
SPEAKER LEVEL INPUT
R L
LEFT RIGHT
SPEAKER LEVEL INPUT
LEFT
BRIDGED
RIGHT
A
B
A
B
SPEAKER OUTPUT
BRIDGED
R L
POWER IN FUSE(30A)
BATT P.CON(REMOTE)
GND
- +
■ Power and Speakers cable connection
Power control
(REMOTE) lead
terminal
A Left output
(Front left)
A Right output
(Front right)
B Left output
(Rear left)
B Right output
(Rear right)
Front left
speaker
Rear left
speaker
Rear right
speaker
Front right
speaker
To prevent fire caused by a short in the
wiring, connect a fusible link or breaker
nearby the battery’s positive terminal.
Connect the ground cable to a metal part of
the car chassis that acts as an electrical
ground passing electricity to the battery‘s
negative - terminal. Do not turn the power
on if the ground cable is not connected.
NOTE
2WARNING
• If a buzzing noise is heard from the
speakers when the engine is
running, connect a line noise filter
(optional) to each of the battery
cable.
• Do not allow the cord to directly
contact the edge of the iron plate
by using Grommets.
Terminal cover
Fire wall
Grommets
Battery
Ground cable
(Black)
Battery cable (Yellow)
Round terminal
(Large)
Power control cable
Power terminal
Pass battery and ground cables through supplied
terminal cover and connect to respective
terminals. After completing connections, fasten
terminal cover over terminal bracket.
A
B
A
B
SPEAKER LEVEL INPUT
R L
LEFT RIGHT
SPEAKER LEVEL INPUT
LEFT
BRIDGED
RIGHT
A
B
A
B
SPEAKER OUTPUT
BRIDGED
R L
POWER IN FUSE(30A)
BATT P.CON(REMOTE)
GND
Round terminal (Medium)
Round terminal (Small)
(Bridged)
A Bridged
B Bridged
If you wish to bridge-connect a
speaker, the speaker impedance must
be no less than 4 ohms.
Connecting a speaker with an
impedance lower than 4 ohms may
damage the unit.
examples:
2CAUTION
≥
4
Ω
L
R ≥
8
Ω ≥
8
Ω
L
R