Kenwood KDC-115S - Manual (Page 15)

— 15 —
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
NOTE
Accessory2
Metal mounting
strap Self-tapping
screw
(commerciall
y available)
Firewall or metal support
Accessory4
Installation ■
Installation
8 mm
MAX.
ø5mm ø5mm
8mm
MAX.
Installing in Japanese-Made Cars
■
T: Toyota cars
N: Nissan cars
T
N
N
T
T/N
Accessory5...for Nissan car
Accessory6 ...for Toyota car
• During installation, do not use any screws except for those
provided. The use of different screws might result in damage to
the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
2CAUTION
Refer to the section "Removing the hard rubber frame (P.16)"
and then remove the hard rubber frame.
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the
accessory screws. 2
1
5
6
Bend the tabs of the
mounting sleeve with
a screwdriver or
similar utensil and
attach it in place.
KDC-115S_U.S 00.12.26 3:40 PM Page 15