Kenwood VR61 - Manual (Page 7)

6
– VR61 and VR62 VR61 and VR62 –
7
Horn Rotation Instructions
• The high frequency horn can be rotated through 90 degrees to allow you to choose
the best horn pattern for your installation.
• From the factory, the horn is set to give a 90 degrees horizontal horn pattern if the
loudspeaker is mounted vertically.
• If you mount the loudspeaker horizontally, you can rotate the horn through 90 degrees
to compensate. This is done using a medium phillips screwdriver as follows:
1. Remove all the screws attaching the grille to the
enclosure, and gently remove the grille.
2. Remove the four screws attaching the horn to the
enclosure.
3. Gently pry the horn assembly away from the
enclosure (it may be stuck due to the gasket seal).
Support the horn so it does not drop when it
comes free.
4. Rotate the horn through 90 degrees (the horn is
marked with 60 and 90 on the edges to show the direction
of the pattern). Be careful not to pull on the speaker wires.
5. Reattach the horn to the enclosure using the four screws.
6. Replace the grille and secure the screws holding it to the enclosure.
(151.7)
62.2
20˚
MOUNTING POINT,
1/4-20 THREADED HOLE.
VR61
DIMENSIONS APPLY
TO TOP AND BOTTOM
TOP
L
C
115.8
FRONT REAR
393.7
241.3
270.4
16.4
Bracket Dimensions
VR61 10.00"(254)
VR62 16.00"(406.4)
0.13"(3.3)
11.50"
(292.1)
3.00"(76.2)
NOTE: Dimensions are in inches, Dimensions in brackets are mm
Tolerance ± 0.03"(0.8 mm)
8.00"(203.2)
2.00"(50.8)
0.40" x 2.25" Full radius
0.31" x 1.38" Full radius
(7.87 x 35.05)
(10.16 x 57.15)
VR61 15.69"(398.5)
VR62 22.44"(570.0)