Kenwood TK-8180 - Manual (Page 44)

TK-8180
44
Item Condition
Measurement Adjustment
Specifications/Remarks Test-
equipment
Unit Terminal Parts Unit Method
ADJUSTMENT
4. Low RSSI 1) Adj item : [n LRSSI] SSG Rear ANT After input signal The following erroneous
adjust Adjust : [ ✳✳✳] panel from SSG, press [B] performance may occur if any
• Narrow SSG output : 12dB SINAD level AF VTVM EXT. SP key. That numeric irregular RSSI adjustment,
(MOD : 1kHz/ ±1.5kHz) Oscilloscope will be stored in such as pressing the [B] key
memory. assigned for determination
2) Adj item : [nL LRSSI] → when it is the ANT OPEN
[nC LRSSI] → [nH LRSSI] state, is performed.
Adjust : [ ✳✳✳] • The antenna bar ( ) cannot
appear correctly.
• Wide 4k 3) Adj item : [s LRSSI] • Scan does not stop.
Adjust : [ ✳✳✳]
SSG output : 12dB SINAD level
(MOD : 1kHz/ ±2.4kHz)
4) Adj item : [sL LRSSI] →
[sC LRSSI] → [sH LRSSI]
Adjust : [ ✳✳✳]
• Wide 5k 5) Adj item : [w LRSSI]
Adjust : [ ✳✳✳]
SSG output : 12dB SINAD level
(MOD : 1kHz/ ±3.0kHz)
6) Adj item : [wL LRSSI] →
[wC LRSSI] → [wH LRSSI]
Adjust : [ ✳✳✳]
5. Squelch 1) Adj item : [n SQLT] After input signal After adjusting SQL, check
(Tight) Adjust : [ ✳✳✳] from SSG, press [B] SQL open/close.
adjust SSG output key. That numeric SSG 12dB SINAD level +10dB
• Narrow : 12dB SINAD+5dB level will be stored in : Open
(MOD : 1kHz/ ±1.5kHz) memory. SSG 12dB SINAD level
: Close
2) Adj item : [nL SQLT] → [nC SQLT] MOD 1kHz/ ±1.5kHz
[nC SQLT] → [nH SQLT] [sC SQLT] MOD 1kHz/ ±2.4kHz
Adjust : [ ✳✳✳] [wC SQLT] MOD 1kHz/ ±3.0kHz
• Wide 4k 3) Adj item : [s SQLT]
Adjust : [ ✳✳✳]
SSG output
: 12dB SINAD+5dB level
(MOD : 1kHz/
±2.4kHz)
4) Adj item : [sL SQLT] →
[sC SQLT] → [sH SQLT]
Adjust : [ ✳✳✳]
• Wide 5k 5) Adj item : [w SQLT]
Adjust : [ ✳✳✳]
SSG output
: 12dB SINAD+5dB level
(MOD : 1kHz/ ±3.0kHz)
6) Adj item : [wL SQLT] →
[wC SQLT] → [wH SQLT]
Adjust : [ ✳✳✳]