Konica Minolta Magicolor 2430DL - Manual (Page 125)

Dual In-Line Memory Module (DIMM) 117
Dual In-Line Memory Module (DIMM)
"
You may need additional memory (DIMM) for complex graphics, and
for duplex printing.
A dual in-line memory module (or DIMM) is a compact circuit board with sur-
face-mount memory chips.
Your printer comes with 32 MB SDRAM printer memory on board. However,
you can upgrade to a maximum of 544 MB of RAM through the installation
of an additional unbuffered SDRAM DIMM. Your printer comes with one free
DIMM slot.
DIMM Specifications
"
Due to the configuration of the printer controller board, only 2 banks of
memory are recognized (single-sided DIMMs). Double-sided DIMMs
have 4 banks of memory, but only 2 of the 4 banks are recognized. As
such, a printer installed with a 512 MB double-sided DIMM may only
recognize half of that memory, 256 MB. In order to recognize all avail-
able memory, you must ensure that you have a single-sided DIMM.
Recommended DIMMs:
1) 64 MB DIMM : 69001605 (PNY), 69000985 (PNY)
2) 128 MB DIMM : CT16M64S4D7E (Crucial)
3) 256 MB DIMM : VS133-S256/HB (Buffalo)
4) 512 MB DIMM : 0286-0005 (Centon)
"
For details about available DIMMs, refer to printer.konicaminolta.com.
Capacity 64 MB, 128 MB, 256 MB, 512 MB
Module Type Unbuffered NonECC
Pin Count 168-pin
Configuration 8M x 64, 16M x 64, 32M x 64, 64M x 64
Data Rate 100 MHz, 133 MHz
CAS Latency 2, 3
Voltage 3.3 V