Konica Minolta Magicolor 2430DL - Manual (Page 108)

Solving Other Problems 100
Printing
takes too
much time. The printer is set to a
slow printing mode
(for example, thick
stock or transpar-
ency). It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The printer is set to
power saving mode. It takes time for printing to start in
power saving mode.
The job is very com-
plex. Wait. No action needed.
The printer memory is
insufficient. Add more memory.
A toner cartridge for a
different region or an
unapproved toner
cartridge is installed
(
INCORRECT
CART. X is dis-
played in the mes-
sage window).
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific printer.
Blank pages
are printed. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges. The image
will not print correctly or not at all, if the
cartridges are empty.
The wrong media is
being used. Check that the media type set in the
driver matches the media loaded in the
printer.
Printer
returned to
READY
before the
configura-
tion menu
was
changed.
The printer was in the
configuration menu
structure without a
selection being made
within two minutes. When in the configuration menu struc-
ture, select your choice within 2 min-
utes.
Symptom Cause Solution