Sharp VIEWCAM VL-A10H - Manual (Page 54)

V L - A 1 0 H / p p . 0 4 6 - 0 4 7 ; 0 0 / 2 / 2 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
Advanced Features
Advanced Features
47
Editing
Video editing lets you refine your videos by
removing unwanted sequences from your tape,
or transposing one sequence with another.
This VIEWCAM lets you monitor the source pro-
gram on the built-in LCD monitor without
having to connect it to an external TV or video
monitor.
Connect the VIEWCAM to a VCR with the sup-
plied audio/video cable, as shown.
Recording
Yellow: To VIDEO IN jack
White: To AUDIO IN (L) jack
Audio/video cable
(supplied)
Playback
POWER TV/VCR SET UP
CHANNEL
REC
PLAY STOP/
EJECT
PAUSE
/STILL
To VIDEO jack (ø2.5)
To AUDIO jack (ø3.5)
Cutting Unwanted Sequences
1
Play back the tape to be edited, and locate
the beginning and end of the sequence
you wish to cut. Write down the tape
counter readings at the beginning and end
of that sequence (see page 35). Then
rewind the tape to the beginning of the
portion that you wish to keep.
2
Load a video cassette into the recording
VCR.
3
Set the Power switch on the VIEWCAM to
VCR. Press the PLAY button (
D) on the
VIEWCAM and the Record button on the
VCR at the same time.
4
Press the Pause/Still button on the VCR to
pause recording when the source tape
reaches the beginning of the sequence to
be cut.
5
Press the Pause/Still or Record button on
the VCR to resume recording when the
source tape reaches the end of the
sequence to be cut.
To stop editing
Press the Stop buttons on the VIEWCAM and
the VCR.
Notes:
• Some of the transitions between edited sequences
may be slightly off.
• There may be picture noise during video search or
still picture playback. This does not imply a defect in
the VIEWCAM.
Setting Edit Mode
Picture quality inevitably decreases when
dubbing from the VIEWCAM to a VCR. To
minimize the quality reduction, set the
VIEWCAM to Edit mode.
1
Set the Power switch to VCR, then press
the MENU button until
appears.
2
Press the ĭ or İ button to select “EDIT”,
then press the SET button ( B) to select
“ON”.
Notes:
• The EDIT mode does not function when the
VIEWCAM is recording.
• After you finish editing, set the EDIT menu item back
to “OFF”.
Note:
• If your VCR has a 21-pin Euro-SCART connector,
use the RCA/21-pin Euro-SCART conversion
connector (QSOCZ0033TAZZ) available from our
main parts distributor detailed on page 53.
Video
0
VIDEO AUDIO (L/MONO) AUDIO (R)
RCA/21-pin Euro-SCART
conversion connector
(QSOCZ0033TAZZ)
21-pin Euro-SCART on VCR
Audio L