Sharp VIEWCAM VL-A10H - Manual (Page 42)

V L - A 1 0 H / p p . 0 2 4 - 0 3 7 ; 0 0 / 2 / 2 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
Useful Features
Useful Features
35
Tape Counter Feature
The tape counter shows elapsed playback or
recording time in hours, minutes and seconds.
(The counter continues to count internally even
while it is not being displayed.) This feature can
be set and used in both VCR and Camera
modes.
Using the Counter
VCR mode
1
Press the MENU button until
appears.
2
Press the COUNTER button ( D) to
display the tape counter.
3
Press the MENU button until
appears, then begin playback.
• You can check the playback time with
the tape counter.
Camera mode
1
Press the MENU button until
appears.
2
Press the COUNTER button ( B) to
display the tape counter.
3
Press the REC START/STOP button to
begin recording.
• You can check the recording time with
the tape counter.
Notes:
• The counter reading may differ slightly from the
actual time. This is especially noticeable when
the tape has been rewound or fast forwarded a
number of times, in which case there can be a
difference of several seconds.
• The tape counter feature will be cancelled if the
power source is interrupted.
To turn off the tape counter
Perform step 1 above, and press the
COUNTER button.
To reset the counter to zero
During playback (or recording), perform steps
1 and 2 above, then press the RESET button at
the point where you wish to reset the counter to
zero. The counter will indicate 0:00.00.
Tape counter
0 1 1 2 4
REW P L A Y S T OP S T I L L F F
VCR mode
NT ER
COU-
E F F .
GAMA
ARCH
S E -
NT E R
COU -
ORY
MEM-
SE T
R E -
ARCH
S E -
0 1 1 2 0
NT E R
COU -
E F F .
GAMA
NT E R
COU -
ORY
MEM-
SE T
R E -
ARCH
S E -
0 0 0 0 0
SE T
R E -
E F F .
GAMA