Sharp VIEWCAM VL-A10H User Manual
Page 43
V L - A 1 0 H / p p . 0 2 4 - 0 3 7 ; 0 0 / 2 / 2 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
Useful Features
36
Using the Counter Memory
Use the counter memory feature when you
want to return to the beginning of a particular
scene. The position where the counter was
reset (0:00.00) is stored in memory to make it
easier to return to that point on the tape.
VCR mode
1
During playback, press the MENU
button until
appears.
• If “MEMORY” is not displayed, press the
COUNTER button.
2
Press the MEMORY button to set the
counter to Counter Memory mode.
• “M” will be displayed to the left of the
counter.
5
Press the REW button (
C).
• The tape will automatically stop when the
counter reaches 0:00.00.
Notes:
• The FF button (
B) can be used in the
same way.
• The tape may stop slightly ahead or behind
the point where you reset the counter to
“M 0:00.00”.
6
Press the PLAY button (
D) to view the
desired scene.
Camera mode
1
During recording, press the MENU
button until
appears.
• If “MEMORY” is not displayed, press the
COUNTER button.
2
Perform steps 2 and 3 above.
3
When you are ready to finish recording,
press the REC START/STOP button.
4
Set the Power switch to VCR, then
perform steps 5 and 6 above.
To cancel Counter Memory mode
Perform step 1 above, and press the MEMORY
button. “M” will disappear from the screen.
Note:
• This feature does not work during video search.
3
Press the RESET button to reset the
counter to zero at the beginning of the
scene that you want to return to later.
NT E R
COU -
ORY
MEM-
SE T
R E -
ARCH
S E -
0
M
0 0 0 0
SE T
R E -
E F F .
GAMA
4
Press the MENU button until
appears. When you are ready to finish
playback, press the STOP button (
A).
NT E R
COU -
ORY
MEM-
SE T
R E -
ARCH
S E -
0 1 8 0 0
E F F .
GAMA
NT E R
COU -
ORY
MEM-
SE T
R E -
ARCH
S E -
0
M
1 8 3 1
ORY
MEM-
E F F .
GAMA
Memory indicator
0
M
1 1 2 4
0
M
0 0 0 0
REW P L A Y
S T OP
S T I L L
F F
REW P L A Y
S T OP
S T I L L
F F