Sharp VIEWCAM VL-A10H - Manual (Page 31)

V L - A 1 0 H / p p . 0 2 4 - 0 3 7 ; 0 0 / 2 / 2 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
Useful Features
24
5
Press the ĭ button to select “SELECT”.
6
Press the SET button ( B) to select
“DATE+TIME” or “DATE”.
When “DATE+TIME” is selected, both the
date and the time are displayed and
recorded.
When “DATE” is selected, only the date
is displayed and recorded.
7
Press the DISPLAY button to turn off the
menu screen, and then press the REC
START/STOP button to begin recording.
Recording the Date and Time
Follow the procedure shown below to record
the date and time, or the date only, along with
the subject.
Note:
• Before performing the procedure below, make
sure that the date and time have been correctly
set (see page 13).
1
In Recording Standby mode, press the
MENU button until
(MENU 1)
appears.
2
Press the PAGE button ( ) to display
MENU 2.
3
Press the ĭ or İ button to select
“DISPLAY”.
S E T
MENU
DA T E
D I S P L A Y O F F
S E T T I NG
1 2 H 2 4 H
S E L E C T DA T E T I ME +
T I ME /
/
2
2 4H
2
1 0 3 0
6 2 0 0 1
MENU
DA T E
D I S P L A Y O F F
S E T T I NG
1 2 H 2 4 H
S E L E C T DA T E T I ME +
T I ME /
/
2
PAGE TURE
P I C -
S E T
5
P A G E
2 4H
2
1 0 3 0
6 2 0 0 1
4
Press the SET button ( B) to select
“AUTO”, “ON”, or “OFF”.
S E T
MENU
DA T E
D I S P L A Y O F F
S E L E C T DA T E T I ME +
T I ME /
2
When “AUTO” is selected, the date/time
is displayed and recorded for 10
seconds at the beginning of the first
recording of each day.
When “ON” is selected, the date/time is
continuously displayed and recorded.
When “OFF” is selected, the date/time is
neither displayed nor recorded.
Note: In “AUTO”, if you wish to record the
date/time a second time that day, repeat the
procedure above and re-select “AUTO”.
S E T
MENU
DA T E
D I S P L A Y AUTO
S E T T I NG
1 2 H 2 4 H
S E L E C T DA T E T I ME +
T I ME /
/
2
2 4H
2
1 0 3 0
6 2 0 0 1
S E T
MENU
DA T E
D I S P L A Y AUTO
S E L E C T DA T E T I ME +
T I ME /
2
2
1 0 3 0
6 2 0 0 1