Questions and answers, Service (customer care), Questions and answers service (customer care) – Siemens Gigaset C34 User Manual

Page 17

Appendix

Gigaset C34 / ISR eng / A31008-M1607-B501-1-7619 / start_guide_time.fm / 22.3.05

4. Do not activate the handset again

until it is dry.

When it has fully dried out you will nor-

mally be able to use it again.

Questions and answers

If you have any queries about the use of

your phone, you can contact us any time

at www.siemens.com/gigasetcustomer-

care. The table below contains a list of

common problems and possible solutions.

Service (Customer Care)

We offer you support that is fast and tai-

lored to your specific needs!
Our Online Support on the Internet:
www.siemens.com/gigasetcustomercare
This site can be accessed at any time wher-

ever you are. It will give you 24/7 support

for all our products. It also provides inter-

active troubleshooting, a list of FAQs and

answers plus user guides for you to down-

load. You will also find frequently asked

questions and answers in the Questions

and Answers section of this user guide in

the appendix.
If you need to examine the phone, require

assistance operating it or wish to make

claims under the warranty, please call

NewPan on 1 700700 727.
If you did not purchase the phone from an

authorized dealer, we will not entertain

any claims made under the warranty.

Authorisation

This product is designed for world-wide

operation, depending on national

approval outside the European Economic

Area (except Switzerland). Country-spe-

cific conditions have been taken into

account. The CE mark attests to the

phone's compliance with the essential

requirements of the R&TTE directive.

The display is blank.
1. The handset is not switched on.

Press the 'end call' key

and hold.

2. The battery is flat.

Charge the battery or replace it (page 5).

The handset does not respond to a key press.
The keypad lock is activated.

Press the hash key

and hold (page 6).

"Base x“ flashes in the display.
1. The handset is outside the range of the

base.

Move the handset closer to the base.

2. The handset has been de-registered.

3. The base is not switched on.

Check the base's mains adapter (page 4).

Handset does not ring.
The ringer is switched off.

Activate the ringer (page 14).

The other party cannot hear you.
You have pressed the

(

§INT§

) key. The hand-

set is "muted".

Switch on the microphone again (page 9).

You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.

Repeat the operation.
Watch the display and refer to the operating

instructions if necessary.