Spectra Logic T50E - Manual (Page 5)

Before You Begin
5
Preparing for Replacement
You have a Valid Backup Library Configuration Whenever you modify the
configuration of the library or a partition, you have the option of saving the
configuration to a USB storage device, as described in the Spectra T50eLibrary User
Guide. The saved configuration can be used to restore a lost configuration.
If you previously saved the library configuration on a USB storage device or uploaded
it to a file on your computer, locate the most current configuration file before
beginning the replacement procedure. You can use this saved configuration to restore
the library configuration after you replace the flash card.
If you have a valid saved configuration, continue with Replacing the Flash (SD) Card
on page 15.
Caution: Do not attempt to save the library configuration if the flash
card is malfunctioning. Any information saved at this point may
be corrupted.
You do not have a Valid Backup Library Configuration If do not have a valid backup
library configuration, or are unable to locate it, you may need to reconfigure your
library manually after replacing the flash card.
In this case, it is important to write down the following library information before
continuing. The items to write down are listed here and described below:
ƒ Option keys
ƒ Encryption keys
ƒ Partition information
ƒ Network information
ƒ Email Users and SMTP IP Address
ƒ AutoSupport Log Profile information for each profile
ƒ General settings
Figure 1 Rear panel components
Ethernet connector
USB ports
Flash card
LCM