Spectra Logic T50E - Manual (Page 16)

Replacing the Flash (SD) Card
16
2. Orient the card with the exposed contacts down and toward the front of the library.
3. Gently push the card into the open slot until it snaps (clicks) into place.
Note: The card inserts easily when it is oriented correctly. Do not force it.
4. Power on the library via the front panel (see Figure 2).
a. Press and hold the front panel power button for two to three seconds until the
button’s LED illuminates.
b. Wait while the library completes its power-on sequence, which takes six to nine
minutes, depending on the library configuration.
5. Calibrate the front panel—After the power-on initialization, the calibration screen
displays. When this screen appears, select Next. It is important for you to use the
stylus to calibrate the front panel, and not your fingers
Note: To properly calibrate the touch screen, press and hold the stylus
on the “+” for two to three seconds. Do not use excessive force.
Figure 3 Flash card orientation.