Sharp MX-M350U - Manual (Page 96)

KEY OPERATOR PROGRAMS
8-6
Pause time setting
This setting is used to select the duration of pauses
that are inserted in destination fax numbers.
Normally the setting is 2 seconds, which means
that each time the [PAUSE] key is touched when
dialing or storing a fax number, a pause of 2
seconds is inserted.
The pause time can be set to any number of
seconds from 1 to 15.
Speaker volume settings
This program is used to adjust the volume of the
five following sounds that are emitted from the
speaker: 1.speaker, 2. ringer volume, 3. line
monitor, 4. fax receive signal, 5. Fax
communication error signal.
To change the volume, touch the desired volume
key. Factory default setting varies with
destinations.
Original print on transaction report
This program is used to have part of the first page
of the fax printed on the transaction report . This
program is used in conjunction with the transaction
report print select setting (at right), and is not
effective when printing of the transaction report is
disabled.
This program is normally configured so that part of
the fax is printed on the transaction report when a
transmission is not successful.
Remote reception number setting
(only when extension phone is connected)
When a call is received (not made) on an extension
phone connected to the machine, fax reception can
be activated by entering a one-digit number and
pressing "
" twice on the phone's keypad. This
number is called the remote reception number, and
you can set it to any number from "0" to "9". The
number is normally set to "5".
Transaction report print select setting
This program is used to select the condition for
printing a transaction report. The condition is set
separately for normal transmission, broadcast
transmission, reception, and confidential reception.
Touch the key to display the next two settings. Select the
print conditions for receptions and confidential receptions
The normal settings are indicated by shading above.
Activity report print select setting
This program is used to have the activity report stored in
the machine's memory printed out at regular intervals.
You can choose to have the report automatically printed each
time the number of stored transactions exceeds 99*, or have the
report printed at a specified time every day (only once per day).
The report is normally set to not print out. Select "AUTO
PRINT AT MEMORY FULL" to have the report automatically
printed when the number of stored transactions (the
combined total of transmissions and receptions) exceeds 99*.
To have the report automatically printed at a
specified time, check the "PRINT DAILY AT
DESIGNATED TIME" box and then select the time
with the "HOUR" and "MINUTE" keys that appear.
Touch the "HOUR" and "MINUTE" keys and then set the
hour by touching the
and keys. Set the minute in
the same way. When finished, touch the [OK] key.
*AR-M351N/AR-M451N only. On the AR-M351U/
AR-M451U, 50 transactions are retained.
KEY OPERATOR PROGRAMS
SPEAKER VOLUME SETTINGS
SPEAKER
RINGER VOLUME
1/2
LINE MONITOR
OK
Volume:High Volume:Low Volume:Medium Off
NOTES
● If you only select the "PRINT DAILY AT DESIGNATED
TIME" setting and the number of recorded transactions
exceeds 99* before the specified time, each new
transaction will delete the oldest transaction (the oldest
transaction will not be printed).
● The activity report can also be printed out on demand
(see "PRINTING OUT SETTINGS" on page 8-11).
SINGLE SENDING BROADCASTING
PRINT OUT ALL REPORT
PRINT OUT ERROR REPORT ONLY
NO PRINTED REPORT
PRINT OUT ALL REPORT
PRINT OUT ERROR REPORT ONLY
NO PRINTED REPORT
RECEIVING CONFIDENTIAL RECEPTION
PRINT OUT ALL REPORT
PRINT OUT ERROR REPORT ONLY
NO PRINTED REPORT
PRINT OUT NOTICE PAGE
NOT PRINT OUT NOTICE PAGE
KEY OPERATOR PROGRAMS
ACTIVITY REPORT PRINT SELECT SETTING
AUTO PRINT AT MEMORY FULL
PRINT DAILY AT DESIGNATED TIME
OK
HOUR MINUTE
13 01