Sharp XG-F315X - Manual (Page 33)

29
Basic
Operation
0 KEYSTONE
ADJUST END
Correcting Trapezoidal
Distortion
When the image is projected either from
the top or from the bottom towards the
screen at an angle, the image becomes
distorted trapezoidally. The function for
correcting trapezoidal distortion is
called Keystone Correction.
• The Keystone Correction can be adjusted up
to an angle of approximately ±40 degrees and
the screen can also be set up to an angle of
approximately ±40 degrees (when the resize
mode is set to “NORMAL” (see page
31 )).
Note
1
2
3
Press KEYSTONE.
• The on-screen display of the Keystone
Correction mode will disappear.
• You can also use KEYSTONE on the pro-
jector.
Press P/Q or O/R to adjust the
Keystone Correction.
• You can also adjust the Keystone Cor-
rection using the adjustment buttons on
the projector.
Press KEYSTONE to enter the
Keystone Correction mode.
• You can also display the on-screen dis-
play of the Keystone Correction mode
with KEYSTONE on the projector.
• To return to the default setting, press RETURN
while the on-screen display of the Keystone
Correction mode is on the screen.
Note
On-screen display
(Keystone Correction mode)
Shrinks upper side.
(Move the slide bar in the + direction.)
Shrinks lower side.
(Move the slide bar in the - direction.)
• While adjusting the image using Keystone
Correction, straight lines and the edges of the
image may appear jagged.
Info
KEYSTONE button
Adjustment buttons
(P/R/O/Q)
RETURN button
About the Auto Keystone Correction
• The projector automatically detects tilt and the
AUTO KEYSTONE feature automatically cor-
rects trapezoidal distortion.
• Automatic Keystone Correction may not work
well in some cases, such as when the screen
is leaning, temperature is extremely high or
low, or zoom is at maximum or minimum. In
these cases, fine adjust the Keystone Correc-
tion following steps 1 to 3.
• You can select “On” or “Off” for the Auto Key-
stone Correction mode. (See page 44 .)
Note