Sharp BD-HP35U - Manual (Page 22)

20
Playback
Before Starting Playback
Loading the Batteries in the Remote
Control
1
Hold in the tab on the battery cover and pull the
cover towards the direction of the arrow.
2
Load the two “AA” size batteries (R-06 size,
UM/SUM-3). Place batteries with their terminals
corresponding to the m and n indications in
battery compartment.
3 Insert the smaller tab of the battery cover into
the opening 1, and press down on the cover
until it clicks in place 2.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
NOTE
• Do not subject the remote control unit to shock, water
or excessive humidity.
• The remote control unit may not function if the Player’s
remote sensor is in direct sunlight or any other strong
light.
• Incorrect use of batteries may cause them to leak or
burst. Read the battery warnings and use the batteries
properly.
• Do not mix old and new batteries, or mix different
brands.
• Remove the batteries if you will not use the remote
control unit for an extended period of time.
Approximate operating range of
remote control
Remote control sensor
15º
30º 30º
15º
*Approx. 22 feet (7m)
Remote control unit
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on
the rear of the Player (1). Then plug into AC outlet
(2).
NOTE
• Place the Player close to the AC outlet, and keep the
power plug within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
• The POWER (ON/STANDBY) indicator blinks while the
Player is preparing for starting up. You cannot turn the
Player on until the POWER (ON/STANDBY) indicator
stops blinking.
• If you are not going to use this Player for a long period
of time, be sure to remove the AC cord from the AC
outlet.