SMC Networks EliteConnect Wireless Bridge SMC2586W-G User Manual
Page 87
Changing the RADIUS Server Setting of Devices
To change the RADIUS server settings of every selected device, carry out
the Change RADIUS Servers command. You’ll be prompted to enter the
Primary RADIUS server and Secondary RADIUS server.
Fig. 108 Changing RADIUS Servers dialog box.
The WPA (Wi-Fi Protected Access) standard uses IEEE 802.1x Port-Based
Network Access Control and RADIUS (Remote Authentication Dial-In User
Service) for advanced WLAN se-curity.
Managing Device Firmware by TFTP
To manipulate firmware and configuration files of every selected device by
TFTP, carry out the various By-TFTP commands. You’ll be prompted to enter
the IP address of the TFTP server (most of the time, specify the IP address
of the computer on which EliteConnect Management Utility runs) and specify
the folder containing or to contain the files. Refer to Section 4.3.2.4.3 for
more information.
Fig. 109 TFTP Server dialog box.
Upgrading Device Firmware
Carry out the Upgrade Firmware by TFTP command.
Backing up Device Configuration
Carry out the Back up Configuration by TFTP command.
Restoring Device Configuration
Carry out the Restore Configuration by TFTP command.
Managing Device Firmware by HTTP
To manipulate firmware and configuration files of every selected device by
HTTP, carry out the various By-HTTP commands. You’ll be prompted to spec-
ify the folder containing or to contain the files. Refer to Section 4.3.2.4.3 for
more information.
86