Sony TRUINSTALL USB 598 - Manual (Page 19)

Installation
Document 2131141. Rev 1.0 Feb.09 19
6. Read the agreement displayed in the “Software License
Agreement” window, and click
Continue .
7. Click Agree to accept the agreement and to continue with
the software installation.
8. If the “Select a Destination” window is displayed, select a
destination volume to install the software, and click
Continue .
9. In the “Standard Install on ...” window, click Install .
10. If a window appears, prompting you to enter your
password, enter your Mac password, and then click
OK .
11. In the window with the message that you will have to
restart your computer, click
Continue Installation .
12. In the “Installation completed successfully” window, click
Restart .
13. After your computer restarts, configure the modem to use
your account (if it was not pre‐activated), as described in
“Activation” on page 23.
Removing the modem
To remove the modem:
1. End your network connection (in Watcher, click
Disconnect ).
2. Close Watcher if it is open.
3. If a microSD card is inserted into the modem, ensure
youʹve completed any file transfers, and then eject the
drive.
4. Pull the modem out of the slot by gripping both sides of
the modem and pulling the modem straight out.
Using the USB extension cable
and laptop clip
Optionally, you can use the provided USB extension cable and
laptop clip. The laptop clip fits on top of your laptop screen
and holds your modem. This allows you to use your modem in
crowded spaces.
Note: To meet FCC (regulatory) requirements, use only the supplied
USB extension cable and laptop clip; other cables and laptop clips
should not be used.