Star Micronics SP298 Series - Manual (Page 127)

124
APPENDIX
Power Supply Specifications
Important!
• When using a printer power supply other than the optional AC adaptor
(PS60A-24 series), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ±5% and more than 2.0 A.
• Be careful about installing the printer in an area where there is noise. Take the
appropriate measures to protect against electrostatic AC line noise, etc.
• The optional cable set can be connected.
Power Supply
AC Adaptor PS60A-24 series, switching type
Input 90 to 264V AC, 50/60Hz
Output 24V DC ± 5%, 2.0A
Plug 3-pin POWER JACK TCP 8927 (Hoshiden brand or equivalent.)
Consumption Current
Conditions: 24V, excluding external equipment driving
Operating
(approximate averages) Continuous ASCII printing + paper feed: 0.6A
Solid block printing + paper feed: 1.0A
Solid block printing: 1.9A
Peak (solid printing): 3.1A
Stand-by
(approximate averages) Paper release deactivated: 0.24 A
Paper release activated: 0.07A