Tv guide on screen™ quick setup sheet – Sharp Aquos LC 45GD5U User Manual

Page 9

QUICK REFERENCE

TV GUIDE ON SCREEN™ QUICK SETUP SHEET

Once you set up the TV according to this operation manual, you are ready to set up TV Guide On Screen!

Note: TV Guide On Screen™ interactive program guide supports cable-ready, cable box and digital cable
services as well as over-the-air broadcast. It does not provide listings for satellite services.

After completing the TV’s initial set up, you see the TV
Guide On Screen Setup

Welcome Screen

Note: If TV Guide On Screen is not set up, pressing

GUIDE

while watching TV will display the

Welcome

Screen

Follow the on-screen instructions

If you previously skipped TV Guide On Screen setup,
you see the

Reminder Screen

Note: If you press

ENTER

and the screen does not

change, make sure that the batteries in the remote
control are properly installed.
If you need to control a cable box and/or a VCR,
complete steps 1 through 3. If not, go to step 4.

Find and Connect the included G-LINK cable
into the G-LINK terminal.

Find the VCR and Cable Box IR Sensors.

To control recording, find the VCR’s IR sensor.

1 Turn the VCR off.
2 Hold the VCR remote so that it touches the

front of the VCR (Figure 1).

3 Move the remote across the front while

pressing

POWER

(Figure 2). (You must press

and release the power button each time you
move the remote; holding down the button will
not work).

4 When the VCR powers on, you have found

the sensor.

5 Remember the location of the sensor, and go

to step 3.

If you have a cable box, repeat this procedure
using the cable box and its remote, and then
go to step 3.

G-LINK cable with
Double-Sided Tape

Place the G-LINK cable(s)

To control a VCR, place one of the G-LINK
wands underneath the VCR approximately 1
inch in front of the sensor you found in step 2.
If you have a cable box, place the other G-
LINK wand approximately 1 inch in front of
the sensor you found in step 2.
Use the double-sided tape to secure each
G-LINK cable.

Use the TV remote for On-Screen Setup

1 Press a/b/c/d and

ENTER

to highlight an

item in a Setup screen.

2 Press

ENTER

to select that item.

a/b/c/d

ENTER

G-LINK cable

Figure 1

Correct

Incorrect

Figure 2

G-LINK

cable

This end is connected to the TV as
shown in step 1.

1 inch

VCR

Cable Box

G-LINK wand