Sharp Aquos LC 45GD5U - Manual (Page 33)

33
Changing channels-Air/Cable
You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below .
Method 1
Using CH r / s on the remote control unit or on the TV.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
• FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons 0–9 , • (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5 s ENT
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0–9 only, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1 s 1 s 5
NOTE
• When you enter 0–9 only, channel selection will be made
if there is no operation for a few seconds.
• If you push “0” by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter
0–9 and • (DOT), channel selection will
be made if there is no operation for a few seconds.
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 s 2 s• (DOT) s1s ENT
5
Air
5
Air ANALOG
11
Cable
1
Cable
115
Cable ANALOG
22 .
Air Air DIGITAL
22 . 1 22 . 1
Air
22
Air
2
Air
Method 4
1. Press INPUT .
2. Press a/b to select CableBox [TV], and then press
ENTER .
3. Press CH r / s to change the channel of the cable
box.
INPUT SOURCE
TV
CableBox [TV]
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5 INPUT5
i.LINK
Watching TV