Sharp Aquos LC 45GD5U - Manual (Page 81)

81
Appendix
• No power
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off/with sidebar
screen.
• Strange color, light color, or color
misalignment
• Power is suddenly turned off.
• No picture
• No sound
• Upgrade is displayed continuously.
Problem Possible Solution
• Check if you pressed TV POWER on the remote control unit. (See page 18.)
If the indicator on the TV is off, press POWER on the TV.
• Is the AC cord disconnected? (See page 6.)
• External influences such as lightning, static electricity, may cause improper
operation. In this case, operate the unit after first turning on the power of the TV
or unplugging the AC cord and replugging it in after 1 or 2 minutes.
• Is the FUNCTION set correctly? Set it to the TV setting position.
• Are batteries inserted with polarity (e, f) aligned? (See page 8.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated near the remote control sensor?
• Is the image position correct? (See page 59.)
• Are screen mode adjustments such as picture size made correctly? (See pages
63 and 64)
• Adjust the picture tone. (See pages 41 to 42.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the input signal setting. (See page 61.)
• Is the sleep timer set? (See page 66.)
• Check the power control settings. (See page 45.)
• The unit’s internal temperature has increased.
Remove any objects blocking vent or clean the vent.
• Is connection to other components correct? (See pages 48 to 53.)
• Is correct input signal source selected after connection? (See page 61.)
• Is the correct input selected? (See page 61.)
• Is a non-compatible signal being input? (See page 83.)
• Is picture adjustment correct? (See pages 41 to 43.)
• Is “On” selected in “Audio Only”? (See page 65.)
• If, after inserting the CableCARD security module, you are unable to receive
broadcast service, remove the CableCARD security module and reinsert.
• Is the volume too low? (See page 34.)
• Is “Variable” selected in “Output Select”? (See page 66.)
• Verify your antenna cable is connected property.
• Reinsert the CableCARD security module. If the trouble still exists after reinserting
the CableCARD security module and verifying the antenna cable, please contact
your Cable Provider Company.
Troubleshooting
Cautions regarding use in high and low temperature environments
• When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly
delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near
a heater, as this may cause the cabinet to deform and the Liquid Crystal panel to malfunction.
Storage temperature: –4°F to +140°F (–20°C to +60°C)