beautypg.com

Operation manual, Safety information – Sharp BD-HP25U User Manual

Page 3

background image

1

OPERATION MANUAL

ENGLISH

Introduction

SAFETY INFORMATION

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER. NO

USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

This symbol warns the user of

uninsulated voltage within the unit

that can cause dangerous electric

shocks.
This symbol alerts the user that

there are important operating and

maintenance instructions in the

literature accompanying this unit.

WARNING:
TO REDUCE THE RISK OF FIRE OR

ELECTRIC SHOCK, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

CAUTION:

USE OF CONTROLS OR ADJUSTMENTS OR

PERFORMANCE OF PROCEDURES OTHER THAN

THOSE SPECIFIED HEREIN MAY RESULT IN

HAZARDOUS RADIATION EXPOSURE.

AS THE LASER BEAM USED IN THIS UNIT IS

HARMFUL TO THE EYES, DO NOT ATTEMPT TO

DISASSEMBLE THE CABINET.

REFER SERVICING TO QUALIFIED PERSONNEL

ONLY.

• This Player is classified as a CLASS 1 LASER

product.

• The CLASS 1 LASER PRODUCT label is located

on the rear cover.

• This product contains a low power laser device. To

ensure continued safety do not remove any cover

or attempt to gain access to the inside of the

product. Refer all servicing to qualified personnel.

“WARNING–FCC Regulations state

that any unauthorized changes or

modifications to this equipment not

expressly approved by the manufacturer

could void the user’s authority to operate

this equipment.”

INFORMATION

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses and can radiate radio frequency energy

and, if not installed and used in accordance with

the instructions, may cause harmful interference

to radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning

the equipment off and on, the user is encouraged

to try to correct the interference by one or more

of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment

and receiver.

–Connect the equipment into an outlet on a

circuit different from that to which the receiver is

connected.

–Consult the dealer or an experienced radio/TV

technician for help.