Schedule, Checking/adding gasoline, Checking tire pressure – Snapper 1300 Series User Manual
Page 20: Lubrication

SCHEDULE
The following schedule should be followed for normal care of your rider and mower. You will need to keep a record of
your operating time. Determining operating time is easily accomplished by multiplying the time it takes to do one job
by the number of times you’ve done the job.
Check tire pressure.
1 6
.
.
Change transmission
Only
is serviced.
Clean battery &cables.
.
Clean/sharpen blades.
1 9
.
Inspect spark plug(s).
*
.
See the engine manufacturer’s owner’s manual.
Change original engine oil after first 5 hours of operation.
More often in hot (over
30” C) weather or dusty operating conditions.
is a sealed unit and requires no regular
interval fluid changes.
CHECKING/ADDING GASOLINE
Check the gas tanks (located on each side of seat deck)
to make sure there is enough gasoline to complete the
job. To add gasoline, remove the gas cap from each
tank. Do not overfill. Leave room in the tanks for fuel
expansion. Refer to your engine manual for gasoline rec-
ommendations. Install and hand tighten the gas caps.
CAUTION
Never use gasoline containing METHANOL, gaso-
hol containing more than 10% ethanol, gasoline
additives, premium gasoline, or white gas because
engine/fuel system damage could result.
CHECKING TIRE PRESSURE
Front tire pressure should be 8 to 12 psi. Rear tire pres-
sure should be 18 to 22 psi.
LUBRICATION
Lubricate the rider and mower as shown in figures 16
24. When a grease gun is shown, wipe the fitting clean,
apply two or three shots of lithium base automotive
grease, and wipe off excess grease. When an oil can is
shown, wipe the area clean, apply a few drops of oil
(SAE
then wipe up drips or spills.
Figure 16. Lubricate Brake Pedal Pivot Point