Sanyo QWEST SCP-8300 - Manual (Page 225)

Making a Ready Link Call by Entering a
Number
To place a Ready Link call by entering a number:
1. From standby mode, enter the Ready Link number you
want to dial.
2. Press to place the Ready Link call. Continue
holding to take the floor and speak.
3. Continue with the Ready Link call, pressing and
holding
to speak and releasing it to allow others
to reply.
4. When the call is finished, press .
– or –
1. Press R-Link (left softkey) or press .
2. Press Go to (left softkey), highlight Enter R-Link# and
press .
3. Enter the Ready Link number you want to dial.
4. Follow steps 2-4 above.
Note: Ready Link numbers must contain ten digits (area code + phone
number). Your Ready Link number is the same as your wireless phone
number.
Ready Link
Section 2K: Using Ready Link 209