Sharp MD-MX10H - Manual (Page 38)

37
When an error message is displayed, proceed as follows:
Error messages
BLANK MD
CAN'T COPY
CAN'T READ
(
:Number or
symbol)
CAN'T EDIT
CAN'T REC
CAN'T WRITE
DISC FULL
E-CD 20
E. OVER
EDIT OVER
Er-MD
(
:Number or
symbol)
NAME FULL
NO DISC
NOT AUDIO
PLAY MD
PROTECTED
TEMP OVER
TOC FORM
(
:Number or
symbol)
TOC FULL
TOC FULL 1
? DISC
Remedy
● Replace it with another disc.
● Replace the CD.
● Replace it with another disc.
● Erase the disc and try recording again.
● Change the stop position of the track and then
try editing it.
● Re-record or replace the MiniDisc.
● Set this unit to the stand-by mode and try to
write the TOC again. (Remove any source of
shock or vibration whilst writing.)
● Replace the disc with another recordable disc.
● Set this unit to the stand-by mode and turn the
power on again.
● Decrease the number of tracks.
● Replace it with a disc that has enough time to
record.
● Set this unit to the stand-by mode and turn the
power on again.
● Shorten the disc or track name.
● Load a MiniDisc.
● Reload the MiniDisc.
● Load a CD.
● Reload the CD.
● Select another track.
● Replace the disc.
● Replace it with another recordable disc.
● Move the write protection tab back to its origi-
nal position.
● Set this unit to the stand-by mode and wait for
a while.
● Replace it with another disc.
● Erase the disc and try recording again.
● Replace it with another recordable disc.
● Replace it with another recordable disc.
● Erase the needless characters.
● Replace it with another disc.
Meaning
● Nothing is recorded.
(Neither music nor disc name is recorded.)
● You tried to record from a copy prohibited CD.
● The disc is damaged.
● TOC information cannot be read.
● MiniDisc not specified.
● A track cannot be edited.
● Recording cannot be performed correctly due
to vibration or shock in the unit.
● The TOC information could not be created prop-
erly due to a mechanical shock or to scratches
on the disc.
● The disc is out of recording space.
● The CD tray is not working properly.
● You chose 21 or more tracks for track editing.
● There is no space to make CD editing on the
disc.
● A MiniDisc is not working properly.
● The number of characters for the disc name or
track name exceeds 40.
● A MiniDisc has not been loaded.
● The MiniDisc data cannot be read.
● A CD has not been loaded.
● The CD data cannot be read.
● The data recorded on this disc is not audio data.
● You tried to record on a playback-only disc.
● The disc is write protected.
● The temperature is too high.
● TOC information recorded on the MD does not
match the MiniDisc specifications or it cannot
be read.
● There is no space left for recording track num-
bers.
● There is no space left for recording character
information.
● The data contains an error.
● MiniDisc not specified.
ERROR MESSAGES