Sharp MD-MX10H - Manual (Page 12)

11
COMPACT DISC OPERATION
■ CD playback 1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD ■ button.
3
Press the
7 7 7 7 7
button to open the disc tray.
4
Place the CD on the disc tray, label side up.
● Be sure to place 8 cm (3") CD in the middle of the disc
tray.
5
Press the
7 7 7 7 7
button to close the disc tray.
● The total number of tracks and the total playing time will
be displayed.
Total number of tracks Total playing time
6
Press the CD
06 06 06 06 06
button to start playback from track 1.
● When the last track has been played back, the unit will
stop automatically.
To interrupt playback:
Press the CD
06
button.
● “
6
” will appear.
● Press the CD
06
button again to resume playback from
the same point.
To stop playback:
Press the CD ■ button.
To remove the CD.
Press the
7 7 7 7 7
button.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Caution:
● Do not carry the unit with a CD left in the disc tray. The
disc may come loose inside the unit and it may be dam-
aged or cause damage to the unit. This may also cause
malfunctions.
● Do not push the disc tray whilst it is moving.
● If the power fails whilst the tray is open, wait until the power
is restored.
● If the disc tray is stopped forcibly, "E-CD20" will appear in
the display and the unit will not function.
If this occurs, press the ON/STAND-BY button to enter the
stand-by mode and then turn the power on again.
● Subjecting the unit to shock or vibration may cause
mistracking.
● Playing certain CDs at a high volume may cause
mistracking. In this case, listen at a lower volume.
● If TV or radio interference occurs during CD operation, move
the unit away from the TV or radio.
1
3,5
6
2
1
6
4
Label side up
8 cm (3")
12 cm (5")
2