Siemens DOME COLOUR CFMC1315-LP - Manual (Page 27)

Configuration
27
Siemens Building Technologies
Fire Safety & Security Products 01.2009
7.2 Network Settings
You can setup your camera basic setting, DDNS, and FTP server by selecting
Network Settings
in the Configuration menu..
7.2.1 Basic Settings
Basic
Camera Name Input your camera name here. The default name is “nwcam05”.
Camera Name Enable
Network
DHCP The IP address is automatically obtained when you select ON;
otherwise, select OFF to manually setup the network setting.
IP Address Input your IP address here when you select DHCP off.
Subnet Mask Please use default number: 255.255.255.0
Default Gateway leave blank as default setting. It is not necessary to enter Default
Gateway if it is not used.
Ask your Network Administrator for Default Gateway information.
Primary DNS (same as above)
Secondary DNS (same as above)
Port
Stream1-Stream2,
cropping1-5: We recommend to use the default, if need to change please check
with system administrator.
UPnP
If this item is selected “ON”, the camera can be detected automatically
by PC. No necessary to have IpFinder installed.
AUDIO output
If this item is selected “ON”, a voice message of camera’s IP address
can be delivered to external speaker via Audio output port.