Woodstock SHOP FOX W1677 - Manual (Page 45)

-43-
W1677/W1711 10" Table Saw
SE
RV
IC
E
To adjust the blade splitter square to the table, do
these steps:
1. DISCONNECT SAW FROM POWER SOURCE!
2. Loosen the set screws shown in Figure 71 to allow
the blade splitter to rotate on the support shaft.
3. Use a try square to adjust the blade splitter 90˚ to
the table as shown in Figure 72. Tighten the set
screws to lock the splitter in place.
To check and align the splitter to the blade, do these
steps
1. DISCONNECT SAW FROM POWER SOURCE!
2. Raise the blade to its maximum height. With a
straightedge, check to make sure that the blade
splitter is in-line with the blade, similar to Figure 29
on Page 21. If it is, tighten the adjustment bolts on
the splitter bracket. If it is not, you need to realign
the splitter to the blade
3. To align the splitter to the blade, loosen the two
adjustment bolts shown in Figure 73 and the two
adjustment bolts on the bracket that attaches the
front of the splitter shown in Figure 71.
4. Align the blade and splitter so they both evenly
touch the straightedge. Tighten all the adjusting
bolts to secure the splitter in place.
Splitter Adjustment
Figure 72. Squaring splitter to table.
Figure 73. Aligning splitter to blade.
The blade splitter MUST be installed and aligned with
the blade before cutting, or the risk of kickback will be
greatly increased and severe injury may occur. If you
cannot get the blade splitter aligned with the blade,
call our Technical Support for help.
Figure 71. Splitter attachment locations.
Front Splitter Bracket
Set Screws
Adjustment Bolts
Adjustment Bolts