Woodstock SHOP FOX W1677 - Manual (Page 42)

-40-
W1677/W1711 10" Table Saw
SE
RV
IC
E
If the blade touches the table insert when you raise
and lower it, then the table needs to be shifted where
it mounts to the cabinet. If you do this and the blade
still needs to be adjusted, the trunnion assembly can be
adjusted inside the cabinet so the blade is repositioned.
To adjust the trunnion assembly, do these steps:
1. DISCONNECT SAW FROM POWER SOURCE!
2. Get another person to help you remove the table
and wings.
3. The first option is to loosen the trunnion assembly
mounting bolts shown in Figure 64 and then shift
the entire trunnion assembly in the appropriate
direction. Tighten the trunnion assembly mounting
bolts.
4. Place the table back on the cabinet and install the
table mounting bolts without tightening completely.
Check the blade position relative to the table insert.
If further adjustments are needed, try to do so by
shifting the table.
Finally, if the above adjustments do not resolve the blade
alignment situation, you need to adjust the geared bear-
ing housing shown in Figure 65.
To adjust the geared bearing housing, do these steps:
1. Get another person to help you remove the table
and wings, and then loosen the blade adjustment
bolt shown in Figure 65.
2. Slide the geared bearing housing in the appropriate
direction, according to the blade position.
3. Place the blade on the arbor and finger tighten the
arbor nut to make sure the blade does not touch any
of the internal parts of the saw.
4. Remove the blade and tighten the blade adjustment
bolt.
5. Replace the table, the wings, and the table insert.
Tighten these securely. Install the blade on the saw
and tighten the arbor nut.
Blade Alignment
Figure 64. Trunnion assembly mounting
bolts.
Figure 65. Lower wheel adjustment
control.
NOTICE
If you move the blade position, make
sure to align blade splitter and check
the miter slot-to-blade alignment.
The table and wings are very heavy
and may cause injury while lifting. Get
help when lifting to reduce the risk of
injury.
Blade Adjustment Bolt
Geared Bearing
Housing