Woodstock SHOP FOX W1677 - Manual (Page 20)

-18-
W1677/W1711 10" Table Saw
SE
TU
P
If your model includes a mobile base kit, or you plan to
use an aftermarket mobile base kit for your saw, we rec-
ommend assembling the saw on the mobile base to avoid
heavy/awkward lifting later.
Assemble your mobile base equipment as detailed in
the instructions included with the mobile base, then put
the saw base unit on the mobile base before continuing
assembly.
Mobile Base
You can mount the extension wings yourself, but it is
easier with help.
Note: If you have a model with long rails and an exten-
sion table, leave the right wing off to make room for the
extension table.
To assemble your table saw, do these steps:
1. Using the fasteners that come pre-installed in the
table, attach the extension wings to the table, as
shown in Figure 18. Do not completely tighten the
bolts at this point.
2. Place a straightedge across the table and the exten-
sion wings, and adjust each wing until it is flush
with the table, then tighten the bolts underneath to
secure the wing in place.
3. Check the overall flatness of the table and exten-
sion wing assembly with a straightedge, as shown in
Figure 19.
Note: If an extension wing tilts up or down at the
outside edges, shim it with masking tape or shim
stock (refer to Shimming Wings on Page 42).
4. Attach the switch bracket to the backside of the
left extension wing with the 5 ⁄
16
"-18 x 1" Phillips flat
head screw, 5 ⁄
16
" flat washer, and 5 ⁄
16
" nut, as shown
in Figure 20.
Assembly
Figure 19. Checking overall table flatness
with a straightedge.
Figure 20. Attaching switch to extension
wing.
Figure 18. Extension wing attached to
table.