Sirius Satellite Radio TTR1 - Manual (Page 72)

72
Appendix: Manual Network Configuration
g. Turn the TUNE Knob to highlight Wired .
Press the TUNE Knob .
h. Will you be using DHCP? Turn the TUNE
Knob to highlight DHCP enable or DHCP
disable and press the TUNE Knob .
i. If you have selected DHCP disable, enter
the following information . Otherwise, continue with step j .
For each entry, Turn the TUNE knob to select the numbers, and press
the TUNE knob to confirm and move to the next number . Press BACK if
you entered an incorrect number .
TIP! You can use the Remote Control to increment the numbers ( ), and move
forward or backward through the number fields ( + and —) .
i . Enter the IP address to use for the radio .
ii . Enter the Subnet Mask IP address for the network .
iii . Enter the Gateway IP address for the
network .
iv . Enter the Primary DNS IP address for
the network .
v . Enter the Secondary DNS IP address
for the network, or leave blank if there
is none .
j. If you have entered the correct information, and the radio is able to
connect to your network, the Connected screen will be displayed . If
not, the Failed to connect screen is displayed . This means that one or
IP settings 3/9
IP address
. 0 . 0 . 0
Subnet mask
. 255 255 . 255 . 0
0
Wired
Wireless
>
>
Connection type 1/9