Sirius Satellite Radio TTR1 - Manual (Page 21)

21
To connect to a wired network using the Network Wizard:
a. At the rear of the radio, remove the compartment cover and
connect an Ethernet cable to the Ethernet connector on the inside
left of the compartment . Refer to “Wired Ethernet Connector”
on page 11 for the location of the Ethernet connector . Replace the
compartment cover .
b. Connect the other end of the Ethernet cable to your home’s wired
network .
c. If you have turned your SIRIUS TTR1 Radio on for the first time, the
SSID screen will already be displayed . Skip ahead to step g .
d. Press MENU and turn the TUNE knob to highlight System Setup .
Press the TUNE Knob .
e. Turn the TUNE knob to highlight
Network . Press the TUNE Knob .
f. Press the TUNE Knob to select
Network Wizard .
g. The radio will scan for networks . When
the scan is complete, turn the TUNE
knob to highlight [Wired] and press
the TUNE knob .
h. If the radio is able to connect to your
network, the Connected screen will
be displayed . If Waiting for Ethernet
Connected
Connected
Some_Network_Name
Other_Network_Name
[Rescan]
[Wired]
[Manual config]
SSID