Sanyo CLT-5812 - Manual (Page 7)

B. Install the rechargeable battery packs into the handsets
Both handsets are powered by a rechargeable battery packs.
The battery recharges automatically when the handset is placed in
the base unit or charging cradle.
Charge the handset battery packs for at least 15-20 hours before
using your new cordless telephone for the first time! To maximize
the charge capacity of your battery pack, DO NOT plug the telephone
cord into the base unit and wall jack until the battery is fully charged.
1
Press down on the handset battery case
cover (use the finger indention for a
better grip) and slide the cover
downward to remove.
2
Plug the battery pack connector (red &
black wires) into the small, black jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the polarity
label in the battery compartment,
connect the battery and listen for a click
to ensure connection.
3
Make sure you have a good connection
by pulling slightly on the battery wires.
If the connection is secure, the battery
jack will remain in place.
4
Place the battery case cover back on the
handset by sliding it upwards until it
clicks into place.
Use only the Sanyo rechargeable battery pack supplied with your cordless
telephone.
IMPORTANT
E5
GETTING
STARTED
Red
Wire Black
Wire
Red
Black
Place the second handset in the charger with the keypad facing forward for
15-20 hours before use.
Note:
UP016DH(CLT5812) ENG OM 3/7/05 5:21 PM Page 5