Sanyo CLT-5812 - Manual (Page 17)

Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones
through the phone lines. However, some phone systems (such as
those in rural areas) still use pulse dialing. The default setting is tone
dialing. Depending on your dialing system, set the mode as follows:
1
When the phone is in standby mode,
press and hold the CID/MENU key.
The following screen appears.
2
Press the VOL/RING key to select ¨ Dial ¨.
3
Press the SELECT/CH key to toggle
between ¨
Tone ¨ and ¨ Pulse ¨.
4
Press the END key and return the handset to the base unit to
complete the setting. The handset returns to standby mode.
Setting the language
1
When the phone is in standby mode,
press and hold the CID/MENU key. The
following screen appears.
2
Press the VOL/RING key to
select ¨ Language ¨.
3
Press the SELECT/CH key to toggle between ¨ Eng ¨, ¨ Fr. ¨ and ¨ Esp ¨.
4
Press the END key or return the handset to the base unit to
complete the setting. The handset returns to standby mode.
E15
GETTING
STARTED
• Make sure your battery pack is fully charged before choosing the dialing mode.
• Dialing mode can only be changed from handset 1. To confirm which handset
is HS1, look at the display indicating “HS1” or “HS2”.
• If you are not sure of your dialing system, set for tone dialing. Make a trial call.
If the call connects, leave the setting as is. Otherwise set for pulse dialing.
• If your phone system requires pulse dialing and you need to send the DTMF
tones for certain situations during a call, you may "switch-over" to tone
dialing. (Refer to "Tone dialing switch-over" on page E18.)
Notes:
UP016DH(CLT5812) ENG OM 3/7/05 5:22 PM Page 15