Directory, Steps for entering names and special characters – Sanyo CLT-5812 User Manual

Page 25

Text mode
Original mode

E23

DIRECTORY

Refer to the letters on the number keys to select the
desired characters.

With each press of a numeric key, the displayed character appears in
the following order: Upper case letters first, lower case letters next
and finally the number corresponding to the key.

If you make a mistake while entering a name

Use the

/TONE/

or #/

key to move the cursor to the

incorrect character.

Press the DELETE/TRANS key to erase, then enter the correct character.
To delete all characters, press and hold the DELETE/TRANS key.

Steps for entering names and special characters

If the next character uses the same number key, you must press the #/

key

to move the cursor over. Otherwise the next time you press the number key, it
changes the character that was previously set.

Note:

UP016DH(CLT5812) ENG OM 3/7/05 5:22 PM Page 23