Sony AT107 - Manual (Page 125)

125
Se
tti
n
gs an
d Adj
u
st
m
e
n
ts
b Note
When HDMI output is performed to equipment not
compatible with DTS signals, the signals will not
be output regardless of the “DTS Output” setting.
Selects the sampling frequency of the audio
signal.
b Notes
• “96 kHz PCM Output” setting has no effect
when audio signals are output from the LINE 2
OUT (R-AUDIO-L) jacks or LINE 3 – TV/
LINE 1/DECODER jack. If the sampling
frequency is 96 kHz, signals are simply
converted to analogue signals and output.
• If the HDMI OUT jack is connected to
equipment not compatible with 96 kHz signals,
48 kHz PCM will be automatically output even
when you select “96 kHz.”
Selects the type of MPEG audio signal.
b Note
If the HDMI OUT jack is connected to equipment
not compatible with MPEG audio signals, the
PCM signals will be automatically output even
when you select “MPEG.”
Selects the dynamic range (difference
between soft and loud sounds) setting when
playing a DVD that conforms to “Audio
DRC.” This affects the output from the
following jacks:
– LINE 2 OUT R-AUDIO-L jacks
– LINE 3 – TV jack
– LINE 1/DECODER jack
– DIGITAL OUT (COAXIAL)/HDMI OUT
jack only when “Dolby Digital Output” is
set to “Dolby Digital -> PCM” (page 124).
96 kHz PCM Output (DVD
VIDEOs only)
96 kHz ->
48 kHz The audio signals of DVD
VIDEOs are converted to
48 kHz and output.
96 kHz All signals containing
96 kHz are output without
conversion. However, the
signals are output at
48 kHz if copyright-
protected signals are
contained.
MPEG Output (DVD VIDEOs
only)
MPEG Select this when the
recorder is connected to an
audio component with a
built-in MPEG decoder.
MPEG ->
PCM Select this when the
recorder is connected to an
audio component without a
built-in MPEG decoder. If
you play MPEG audio
sound tracks, the recorder
outputs stereo signals via
the DIGITAL OUT
(COAXIAL) jack.
Audio DRC (Dynamic Range
Control) (DVDs only)
On Makes low sounds clear
even if you turn the volume
down.
Off Normally select this
position.